Diamond patterned router, Chip breaker, Two flute endmill, V-groove cutter |  |
| Type |
Diameter range |
|
Application |
| RCF | 0,4 to 3,175mm |
|
TCT RCF series router with diamond cut geometry for general purpose contouring can approach a maximum tool life when tools are used on well maintained equipment which is assisted with good pressure foot holding system.
|
| RTF |
0,8 to 2,4 mm |
|
TCT RTF/RTD series router with special rough teeth can produce a higher productivity under high chip load operation parameter, which should be assisted with a better vacuum system.
|
| RTD |
1,6 to 2,4 mm |
|
Ref. RTD |
| CBFB |
0,8 to 3,175 mm |
|
TCT CBFB series router with better chip removal property insures a fine, sharp edge for milling surface. Besides, to compare with diamond cut router,CBFB with smaller vibration is helpful extending spindle life in routing process.
|
| E200R |
0,4 to 3mm |
|
End mill with 2 flutes, right hand, up cut: TCT E200R series end mill is designed with appropriate rank angle to maintain a sharp cutting edge and excellent surface finish on Teflon, flexible boards, aluminum and plastic materials. Besides, E200R is ideally suited for BGA boards to meet its strict requirements.
|
| E300S |
0,4 to 3mm |
|
End mill with 2 flutes, right hand, up cut: TCT E300S series end mill with 3 straight flutes is especially suited for the conductor routing of gold finger to have an excellent sharp cutting edge quality.
|
| AR |
1,6 to 2,4mm. |
|
TCT AR series is especially designed for aluminium board contouring. It can improve the burr problem and provide sharp edge quality.
|
| CC |
3,2 to 6,5mm. |
|
TCT CC series chamfer cutter is designed to produce shape groove of pcbs. CC is mainly used for inside slot chamfering or screw hole drilling.
|
| VG |
|
|
Can be used on standard routing machine to make V-groove.
|
|
